This license qualifies the holder to contract unlimited air conditioning work, refrigeration, heating, and ventilating systems including duct work, lift station equipment, piping, pneumatic control piping, gasoline tanks, pumps, standpipes, air piping, vacuum lines, oxygen, nitrous oxides, ink and chemical piping, fuel transmission lines, tanks, and pumps.
Read the excerpts from the Florida Licensing Law below for more information.
You can find the state required reference books in our bookstore.
State Booklist for the Florida Mechanical Contractor License Exam»
We offer several options to help prepare for the state exam.
Exam Preparation Information for the Florida Mechanical Contractor License»
Excerpts from the Florida Licensing Law ( F.S. Ch. 489 ):
489.105(3)(i) – "Mechanical contractor" means a contractor whose services are unlimited in the execution of contracts requiring the experience, knowledge, and skill to install, maintain, repair, fabricate, alter, extend, or design, when not prohibited by law, central air-conditioning, refrigeration, heating, and ventilating systems, including duct work in connection with a complete system only to the extent such duct work is performed by the contractor as is necessary to make complete an air-distribution system, boiler and unfired pressure vessel systems, lift station equipment and piping, and all appurtenances, apparatus, or equipment used in connection therewith, and any duct cleaning and equipment sanitizing which requires at least a partial disassembling of the system; to install, maintain, repair, fabricate, alter, extend, or design, when not prohibited by law, piping, insulation of pipes, vessels and ducts, pressure and process piping, pneumatic control piping, gasoline tanks and pump installations and piping for same, standpipes, air piping, vacuum line piping, oxygen lines, nitrous oxide piping, ink and chemical lines, fuel transmission lines, and natural gas fuel lines within buildings; to replace, disconnect, or reconnect power wiring on the load side of the dedicated existing electrical disconnect switch; to install, disconnect, and reconnect low voltage heating, ventilating, and air-conditioning control wiring; and to install a condensate drain from an air-conditioning unit to an existing safe waste or other approved disposal other than a direct connection to a sanitary system. The scope of work for such contractor shall also include any excavation work incidental thereto, but shall not include any work such as liquefied petroleum gas fuel lines within buildings, potable water lines or connections thereto, sanitary sewer lines, swimming pool piping and filters, or electrical power wiring.
489.111 – Licensure by examination –
(1) – Any person who desires to be certified shall apply to the department in writing.
(2) – A person shall be eligible for licensure by examination if the person:
(a) – Is 18 years of age,
(b) – Is of good moral character, and
(c) – Meets eligibility requirements according to one of the following criteria:
1. – Has received a baccalaureate degree from an accredited 4-year college in the appropriate field of engineering, architecture, or building construction and has 1 year of proven experience in the category in which the person seeks to qualify. For the purpose of this part, a minimum of 2,000 person-hours shall be used in determining full-time equivalency.
2. – Has a total of at least 4 years of active experience as a worker who has learned the trade by serving an apprenticeship as a skilled worker who is able to command the rate of a mechanic in the particular trade or as a foreman who is in charge of a group of workers and usually is responsible to a superintendent or a contractor or his or her equivalent, provided, however, that at least 1 year of active experience shall be as a foreman.
3. – Has a combination of not less than 1 year of experience as a foreman and not less than 3 years of credits for any accredited college-level courses; has a combination of not less than 1 year of experience as a skilled worker, 1 year of experience as a foreman, and not less than 2 years of credits for any accredited college-level courses; or has a combination of not less than 2 years of experience as a skilled worker, 1 year of experience as a foreman, and not less than 1 year of credits for any accredited college-level courses. All junior college or community college-level courses shall be considered accredited college-level courses.